什么是服务处理器以及如何使用它？

2023-04-08 08:18| 来源: 网络整理| 查看: 265

ONTAP 9

运行 system node service-processor network modify 命令以启用 SP 并在集群模式 Data ONTAP 系统上对其进行配置：

cluster1::> system node service-processor network modify -node node1 -address-type IPv4 -enable true -ip-address 192.168.1.201 -netmask 255.255.255.0 -gateway 192.168.1.1

可以使用以下命令验证设置：

cluster1::> system service-processor network show Address Node Status Type Link State IP Address ------------- -------------- --------- ----------- ------------------------ node1 online IPv4 up 192.168.1.201

DHCP: v4 MAC Address: ab:cd:ef:fe:ed:01 Network Gateway: 192.168.1.1 Network Mask (IPv4 only): 255.255.255.0 Prefix Length (IPv6 only): - IPv6 RA Enabled: - Subnet Name: - SP Network Setup Status: succeeded

node1 online IPv6 disabled -

DHCP: none MAC Address: ab:cd:ef:fe:ed:01 Network Gateway: - Network Mask (IPv4 only): - Prefix Length (IPv6 only): - IPv6 RA Enabled: - Subnet Name: - SP Network Setup Status: not-setup

node2 online IPv4 up 192.168.1.202

DHCP: v4 MAC Address: ab:cd:ef:fe:ed:02 Network Gateway: 192.168.1.1 Network Mask (IPv4 only): 255.255.255.0 Prefix Length (IPv6 only): - IPv6 RA Enabled: - Subnet Name: - SP Network Setup Status: succeeded

node2 online IPv6 disabled -

DHCP: none MAC Address: ab:cd:ef:fe:ed:02 Network Gateway: - Network Mask (IPv4 only): - Prefix Length (IPv6 only): - IPv6 RA Enabled: - Subnet Name: - SP Network Setup Status: not-setup

4 entries were displayed.

要重新启动 SP ，请运行 system node service-processor reboot-sp 以下命令：

cluster1::> system node service-processor reboot-sp -node node1

Note: If your console connection is through the SP, it will be disconnected. Do you want to reboot the SP ? {y|n}: y

【本文地址】

公司简介

联系我们